• Control pressure in individual devices
• For use in double or single acting systems
• Direct acting, poppet style, adjustable, cartridge construction
• Cartridge may be installed directly into your manifold
• Model No. 70-5410-10 Set the Range from 750 to 4,500 psi.Repeatability is ±7% of set pressure
• Model No. 70-5410-01 Set the Range from 150 to 900 psi.Repeatability is ±10% of set pressure
• Maximum inlet pressure 5,000 psi
• Pressure Reducing Cartridge is interchangeable with the Pressure Limiting Cartridge in the same mounting cavity
• Two-port design eliminates need for a third fluid line to drain bybass flow (internal leakage) back to system reservoir
• Recommended Filtration: 25 Micron (NOM)/ 40Micron (ABS) (minimum)

Operation: The Pressure Reducing Valve (PRV) is a Normally Open (N/O) pressure control device.The valve remains open and fluid flows freely to downstream devices (from the valve to devices) until the pressure in the valve reaches the pressure (adjustable) set-point. At the set-point pressure the valve closes, blocking further flow and pressure rise to the downstream devices. If there is a sufficient down stream pressure loss (from the valve to devices), the PRV will re-open, allowing flow to pass through the valve until the pressure again reaches the valve set-point. The PRV is designed for use in both single and double acting systems.

For proper sealing, mating surface must be flat within 0.003 in. with a maximum 63 µin R_a surface finish.

• Control pressure independently on both the clamp and unclamp side of the fixture regardless of pump pressure setting.
• Eliminate the wait for full system pressure to finish cycling workholding components.
• Set the Range from 750 psi to 4,500 psi (Recommended).
• For use in double or single acting systems.
• DO3 Mounting to use on pump stack or as a remote mounted valve.