Swing Clamp plunger shown in the
extended LH cam position.

WARNING! Never allow swing arm to contact workpiece or fixture during arm rotation.

 ** Cylinder capacities are listed at 5,000 psi maximum operating pressure, with a standard length VektorFlo arm installed. Minimum operating pressure is 750 psi for single acting, 500 psi for double acting. The clamping force is adjustable by varying the hydraulic system pressure.

To determine the approximate output force for your application, divide the cylinder capacity shown above by 5000, and multiply the Resultant Number X Your System Operating Pressure to obtain the approximate clamping force for your application. (Actual force will vary slightly due to internal cantilever loading, frictional loss, and/or return springs.)

*** To allow for piece part height variations, it is recommended that the vertical travel be set at about 50% of the vertical stroke.

**** To insure maximum service life and trouble-free operation, restrict fluid flow to the level indicated in the Clamp Time and Fluid Flow Rate chart.

• Simplified cavity design makes machining of pocket and installation easier
• Eliminates the need for exposed plumbing, installs nicely in custom designed chip
  shedding fixtures
• Uses SAE O-ring mounting configuration
• Bury deeply in fixtures to reduce overall installed height and simplify design
• Arms sold separately
• Simplified pocket design with O-ring face seal on top allows use of some standard port tooling
• Only one O-ring must pass cross porting during installation, and only one (not two) ports must be passed (but should not touch), reducing the chance of O-ring damage during installation
• Hardened V-cam tracks resist damage and give you a built in extra cam (opposite swing direction) or straight line option should you accidentally damage one. Specify left, right or straight cam and we will preset the swing when you order

U.S. Patent No.
5,820,118
6,886,820 B1

*Single Acting Models must be vented, do not install them in blind holes

All dimensions are in inches.

*The 30° lead in angle is to ensure trouble-free seal installation

All dimensions are in inches.

Note: Flexible honing of cavity is strongly recommended. Flex-Hone™ is a registered trademark of Brush Research Manufacturing Co. Inc., Los Angeles, CA, 323-261-2193. Please contact Brush Research for additional information.